Fan Installation
Mounting fan by rubber pins
1. Hold the rubber pin head and pull it through the fan screw whole from outside of the chassis, until it is kept in position.
2. Fix the rubber washer on each rubber pin from inside of the chassis against the chassis wall. This helps absorb vibration between chassis and fan.
3. Align the fan holes with the rubber pins; install the fan from inside of the chassis by pulling each end of the rubber pin, until the fan is secured.
Mounting fan by rivets
1. Hold and position the fan whereas mounting holes are aligned with the chassis screw holes on chassis. (Check direction of air flow during fan installation)
2. Mount the screws with Phillips screw driver from outside of the chassis, until all the screws are secured inside the fan holes.
Fan plug power connection
motherboard fan socket.
motherboard fan socket.
2.Connect them to PSU power socket.
Important safety guidelines
1. Switch off the power while installing the fans to prevent the electric shock.
2. Keep hands dry during installation. Wet hands could cause electric shock or computer malfunction.
3. Install the fan under normal voltage. Installing the fan out of the operating voltage could cause fire hazard.
4. Do not modify the fan to avoid fire hazard or electric shock. 5. Do not touch the running fan. This could hurt your fingers or cause fan malfunction.
5. Do not touch the running fan. This could hurt your fingers or cause fan malfunction.